Overview
The PKG-CCRP is a two part solution providing a fiber optic remote extension of the Exelis RO™ Tactical Radio handset / data port to a desk set monitor. The solution allows the radio to be mounted in a convenient location to allow a shorter permanent antenna cable, maximizing the signal strength, while allowing the radio to be used in a location where it may not normally function.
>The 2U high rack mount chassis provides power regulation for the radio, local connector access for install verification/configuration/monitoring, and a fiber optic interface for remote connection of the radio accessory port. All installed devices are modular and can be easily accessed from the rear of the chassis. Front panel LEDs show system power and radio PTT status.
The desk set monitor provides for connections of the same radio accessories (handset, headset, PDA device, etc.) as well as a separate rear serial port (standard 9 pin connector) for connection to a PC or other serial device while allowing for monitoring of incoming audio via the desk set speaker. Separate volume controls allows adjustment of the handset volume apart from the monitor speaker volume. The monitor speaker has a mute control, allowing quick silencing of the speaker without having to adjust the volume. LED indictors show the monitor speaker mute status as well as fiber link status. The rear serial port allows simultaneous data and audio use.
Radio Rack (RMC-CCRP):
- Provides housing and power for an Exelis RO™ Tactical Radio
- Hot Swappable Redundant Power Supplies
- Supports all functions of the
RO ™ Tactical Radio including PTT and serial data connection - Front panel access for local handset connection
- Local / Remote selector
- Status indicators
- Includes all radio connections
- Easy access
for external antenna connection
Desktop Remote (CCRP-B):
- Full handset support
- Built-in speaker for audio monitoring
- Separate volume control for handset and speaker
- D9 Serial port connector for remote radio monitoring
| AUDIO SPECIFICATIONS (FOI-7280) |
||||||
|
|
Min |
Typ |
Max |
unit |
||
| Frequency Response |
20 Hz to 25 KHz |
-0.5 |
0 |
0.5 |
dB |
|
| 26 KHz to 45 KHz |
-1.5 |
0 |
1.5 |
dB |
||
| Third Harmonic Distortion plus Noise (THD+N)* - 1 KHz @ +4 dBu |
- |
0.015 |
- |
% |
||
| Input Level (with max 1% THD) |
-60 |
0 |
+17 |
dBu |
||
|
|
- |
|
VDC |
|||
| Input Sensitivity |
0.020 |
0.775 |
7 |
Vrms |
||
| Input Noise Floor ref +0 dBu |
- |
-80 |
- |
dBu |
||
| Input Impedance |
- |
2 |
- |
KΩ |
||
| Output Level |
0.02 |
0.775 |
7 |
Vrms |
||
| Output Impedance |
- |
150 |
- |
Ω |
||
| Output for Use with Nominal |
- |
600 |
- |
Ω |
||
| Audio Latency (point to point) |
- |
1260 |
- |
µs |
||
| Sampling Rate |
24 bit / 96kHz or 24 bit / 48 kHz |
|||||
| *Hum & Noise are measured with an AES17 compliant filter at 20 kHz. Temperature condition @+10 - +25° C. |
||||||
| SERIAL DATA SPECIFICATIONS |
||||||
| Min |
Typ |
Max |
unit |
|||
| RS-232 |
Output Levels, 3KΩ Termination |
±5 |
±5.4 |
- |
VDC |
|
| Input Levels |
-15 |
- |
+15 |
VDC |
||
| Input Threshold |
±3 |
- |
- |
VDC |
||
| Data Rate |
0 |
- |
1 |
Mbps |
||
| Input Termination |
3 |
- |
2.3 |
KΩ |
||
| ELECTRICAL SPECIFICATIONS |
|||||
| Min |
Typ |
Max |
unit |
||
| Environmental |
Storage Temperature (°C) |
-40 |
- |
85 |
°C |
| Operating Temperature (°C) |
0 |
- |
50 |
°C |
|
| Power Requirement |
Voltage Range |
7 |
9 |
12 |
VDC |
| Supply Current, no SFPs |
- |
600 |
- |
mA |
|
| OPTICAL SPECIFICATIONS |
|||||
| External SFP Interface |
Min |
Typ |
Max |
unit |
|
| Data Rate |
- |
346 |
- |
Mbps |
|
| Recommended Jitter |
- |
40 |
- |
psec |
|
| Operating Voltage |
- |
3.3 |
VDC |
||
| Maximum Current |
- |
- |
500 |
mA |
|
| Optical Modules |
SFP MSA (SFF-8431, SFF-8432, SFF-8433) compliant slot, data rate 266 Mbps - 1.25 Gbps |
||||
| Output Power (50µ fiber) |
-9 |
- |
-4 |
dBm |
|
| Extinction Ration |
9 |
- |
- |
dB |
|
| TX Optical Wavelength |
830 |
850 |
860 |
nm |
|
| RX Sensitivity |
- |
- |
-18 |
dBm |
|
| Max Received Power |
0 |
- |
- |
dBm |
|
| RX Optical Center Wavelength |
770 |
- |
860 |
nm |
|
| The CCRP is optimized for
|
|||||
Spare Parts
| RMC-CCRP | 19 in EIA
|
| PSM-2010 | Redundant power supply F/U/W RMC-2xxx series rack mount chassis, 90-260 VAC, 40-400 Hz input, 75 Watts |
| CMA-CCRP | Custom carrier tray for radio with integrated power supply. Radio not included. |
| CMA-2100 | Fiber optic conversion tray. Includes FOI-7280 mounted with fiber jumpers and copper breakout for radio connections. |
| CCRP-B | Remote desktop unit with speaker, handset
|
